Prepare 300-115 exam with the help of dumps. You can Pass your Cisco 300-115 exam with real exam question answers. Authentic 300-115 study material available for your IT exam preparation. Your can easily prepare and pass your Certification exam on first attempt. You can get all Cisco exam study material and 300-115 exam related information here on dumps4download website.
Our all 300-115 preparation material fully verified by IT professionals. we are fully sure that you will love to prepare your exam with us. These are the exam question answers that you can get free of cost here on dumps4download. If you want to get complete 300-115 PDF and VCE you can choose our Premium files. 100% guaranteed that you will pass your Implementing Cisco IP Switched Networks
Implementing Cisco IP Switched Networks (SWITCH 300-115) is a 120-minute qualifying exam with 45?55 questions for the Cisco CCNP Routing and Switching and CCDP certifications. The SWITCH 300-115 exam certifies the switching knowledge and skills of successful candidates. They are certified in planning, configuring, and verifying the implementation of complex enterprise switching solutions that use the Cisco Enterprise Campus Architecture.
The SWITCH exam also covers highly secure integration of VLANs and WLANs.
The following topics are general guidelines for the content that is likely to be included on the exam. However, other related topics may also appear on any specific version of the exam. To better reflect the contents of the exam and for clarity, the following guidelines may change at any time without notice.
The following course is the recommended training for this exam.
- Implementing Cisco IP Switched Networks (SWITCH)
- Implementing Cisco IP Switched Networks (SWITCH) E-Learning
Courses listed are offered by Cisco Learning Partners-the only authorized source for Cisco IT training delivered exclusively by Certified Cisco Instructors. Check the List of Learning Partners for a Cisco Learning Partner nearest you.Exam Number : 300-115 SWITCHAssociated Certifications : CCNP Routing and SwitchingCCDPDuration : 120 minutes (30-40 questions)Available Languages : English, JapaneseRegister : Pearson VUE
Refer to the exhibit.
B.username cisco with password cisco
C.no username with password linepass
D.login authentication default
A network engineer is extending a LAN segment between two geographically separateddata centers. Which enhancement to a spanning-tree design prevents unnecessary trafficfrom crossing the extended LAN segment?
A.Modify the spanning-tree priorities to dictate the traffic flow.
B.Create a Layer 3 transit VLAN to segment the traffic between the sites.
C.Use VTP pruning on the trunk interfaces.
D.Configure manual trunk pruning between the two locations.
Which statement about restrictions for multichassis LACP is true?
A.It is available only on a Cisco Catalyst 6500 Series chassis.
B.It does not support 1Gb links.
C.Converting a port channel to mLACP can cause a service disruption.
D.It is not available in VSS.
Which command would a network engineer apply to error-disable a switchport when a
packet-storm is detected?
A.router(config-if)#storm-control action shutdown
B.router(config-if)#storm-control action trap
C.router(config-if)#storm-control action error
D.router(config-if)#storm-control action enable
Which database is used to determine the validity of an ARP packet based on a valid IP-to-MAC address binding?
A. DHCP snooping database
B. dynamic ARP database
C. dynamic routing database
D. static ARP database
Which statement describes what happens when a switch enters dual active recovery
A. The switch shuts down and waits for the VSL link to be restored before sending traffic.
B. All interfaces are shut down in the formerly active virtual switch member, but the new
active virtual switch forwards traffic on all links.
C. The switch continues to forward traffic out all links and enables spanning tree on VSL
link and all other links to prevent loops.
D. The VSS detects which system was last in active state and shuts down the other switch.
Which information does the subordinate switch in a switch stack keep for all the VLANs that
are configured on it?
A. VLAN database
B. DHCP snooping database
C. spanning trees
D. routing information
Which command configures an HSRP group to become a slave of another HSRP group?
A. standby slave
B. standby group track
C. standby follow
D. standby group backup
A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor relationships. What would cause the output to show only the single neighbor?
A. The routers are connected via a Layer 2 switch.
B. IP routing is disabled on neighboring devices.
C. Cisco Express Forwarding is enabled locally.
D. Cisco Discovery Protocol advertisements are inconsistent between the local and remote devices.
What is the maximum number of switches that can be stacked using Cisco StackWise?